Object:

Campsite Grubhof

 

Subtitle:

Camping in the State of Salzburg: Grubhof goes for large and stylish

Date:

24.02.2014

City:

St. Martin bei Lofer, Austria

Completion:2013
Task:

Modernisation of the campsite sanitation facilities

Size:

500 m²

Products used:

PCI Gisogrund 

PCI FT-Flex

PCI Nanoflott light

PCI Pecitape 120 

PCI Pecitape WS 

PCI Seccoral 2K Rapid

PCI Silocoferm S

PCI Durafug NT

Owner:

Grubhof - Maria and Robert Stainer

Architect:

Master Builder Ing. Franz Piffer,

Project Manager: Thomas Groß

Company:

Fliesen Schwaiger GmbH, 5092 St. Martin bei Lofer, Austria

Specialist advice:

PCI Technical Tiling Specialist: Michael Loindl

 

Download project report

The Grubhof campsite in the middle of St. Martin bei Lofer reflects the characteristics of the region: closeness to nature, tradition and warm hospitality. Since 2013, the new 5-star sanitation facility has increased the level of comfort of the approximately twelve-acre campsite by taking the load off the existing sanitary facilities during the high season and shortening the paths between the pitches and wash facilities the whole year round. The new complex comprises seven family bathrooms, each ten metres square. All of them are equipped with a toilet, a generous shower, wash basins and storage space. The high frequency of use of 1,200 campsite visitors per day puts considerable pressure on the design and execution of the wet rooms. The installed coverings therefore have to look the part, have suitable non-slip properties and be easy to clean on a daily basis. A total of 350 square metres of flooring and150 square meters of wall were covered with large-format porcelain stoneware tiles. Below the surface of the beautiful tiles and panels, high quality products manufactured by PCI Augsburg ensure the structure of the building is suitably water resistant. While effectively protecting against the demanding humid conditions, the innovative ingredients also introduce a degree of flexibility into the bond. In accordance with ÖNorm B 2207, wall surfaces that are heavily affected by moisture, such as those in sanitary facilities, are classified as stress class W3, and the corresponding floor areas as stress class W4. The substrate must therefore be suitably protected against moisture penetration. Such waterproofing posed a real challenge for the installers because the tiling had to be applied to a very fresh yet still shrinking screed. In order to protect the subsequent tile skin from damage, a layer of PCI Seccoral 2K Rapid fast-setting waterproof slurry was applied over the primer. The static separation of the insulation on the sometimes very long corridors with equally long separation joints is another demanding task. The individual inlets and outlets, and the floor-to-wall connections were sealed to the waterproofing with various sealing strips and collars, while the elastic joints were created using silicone joint sealant. Thanks to the effective combination of the team and the materials, it didn't take long to construct the new sanitation block No. 3 and have it up running in time for the new season.